T6 Programs
2 Servo Ailerons
MIX 1 (or any unused mix)
Source: CH 1
Des: CH 5 (or CH 6)
Up Rate: 100%
Down Rate: 100%
Switch: On
Flaps
MIX 1 (or any unused mix)
Source: VR A (or VR B)
Des: CH 5 (or CH 6)
Up Rate: 0% Down Rate:
100% Switch: SW A (or
SW B)
Use a servo “Y” cable to connect servos. Use VR A or VR B to adjust degree of
flaps, and switch flaps on or off with SW A or SW B. If those switches are not in
use by another function. Otherwise operate flaps with either VR A or VR B and set
“Switch” to on.
Delta/Elevons
MIX 1 (or any unused mix)
Source: CH 1
Des: CH 2
Up Rate: 100%
Down Rate: 100%
Switch: On
To Next Page
Loading...
