MIX 2
Source: VR A (or VR B)
Des: CH 1
Up Rate: 75%
Down Rate: 75%
Switch: SW A (or SW B)
MIX 3
Source: VR A (or VR B)
Des: CH 5 (or CH 6)
Up Rate: -75% Down
Rate: -75% Switch: SW
A (or SW B)
Use VR A or VR B to select either flaperons or spoilerons, and the degree of
travel. The percentages of mix 2and 3 can be adjusted to suite your models flight
characteristics. The Up rate and Down rate percentages can be adjusted as
necessary to your application. However higher percentages result in less aileron
travel.
Gyro Gain
MIX 1 (or any unused mix)
Source: VR A (or VR B)
Des: CH 5 (or CH 6)
Up Rate: 100%
Down Rate: 100%
Switch: On
You will need to center VR A (or VR B) in T6config and mark it on the TX case
for easy reference.
To Next Page
