www.fmiproducts.com
124387-01D 33
POSSIBLE CAUSE
1. Gas leak. See Warning
statementabove
1. High or gusting winds
2. Low line pressure
3. Pilot is partially clogged
4. Inner vent pipe leaking
exhaust gases into system
5. Bad thermopile or thermo-
couple
6. Vent cap improperly in-
stalled or blocked
1. Burner orice clogged
2. Inlet gas pressure is too
low
3. Thermopile leads discon-
nected or improperly con-
nected
4. Thermopile is defective
OBSERVED PROBLEM
Fireplace produces unwant-
ed odors
Fireplace shuts off in use
Burner does not light after
pilot is lit
REMEDY
1. Locate and correct all leaks (see
Checking Gas Connections,
page 22)
1.
Fireplace has been tested for up to
40 mph winds. However, extreme
conditions may occur. See Light-
ing Instructions, page 25
2. Check local propane/LP or natu-
ral gas company
3. Clean pilot (see Cleaning and
Maintenance, page 28)
4. Locate and correct all vent con-
nections (see Venting installa-
tion, page 12)
5. Replace faulty components
6. Check for proper installation or
remove debris or blockage.
1. Clean burner (see Cleaning
and Maintenance, page 28) or
replace burner orice
2. Contact local propane/LP or
natural gas company
3. Reconnect leads to TP and
TPTH terminals on control
valve
4. Replace thermopile
TROUBLESHOOTING
Continued
To Next Page
Loading...
