focuway M2 - Q&A; How to Start Recording; How to Switch to Photo Mode

20
Version: Production version and system serial number.
Q&A
How to Start Recording?
If the Dash Cam has been successfully installed in the car, it will
automatically turn on and start recording when the engine starts (for
most cars on the market). If your Dash Cam does not automatically
start and start recording when the engine starts (this usually depends
on your car model), please press the POWER button to turn on the
camera manually. Then press OK button to start recording. When the
Dash Cam is recording, there is a flashing Red Dot appears in the
upper left corner of the screen.
How to Switch to Photo Mode
Please confirm the dash cam is not recording, short press MODE
Button to enter the Photo Mode. Press OK button to take a photo.
Under the Photo mode, short press the MENU button to enter its
Camera Settings. The settings menus are shown below:
We recommend that you use the default value