FOLSOM IP-2003 - Input Remote Commands

Manual # 26-0302000-00 / Revision E ImagePRO – Multi Format Image Processor
69
Input Remote Commands
Command:
ACQ mode
Description: Turns Auto acquisition mode off/on.
Parameters: mode [0 | 1] Off | On
Query:
ACQ?
Returns Auto acquisition mode in the format
= mode
Example: ACQ 0 (Turns auto acquisition mode off)
ACQ? (Queries for auto acquisition mode)
Command:
DINT in mode
Description: Sets De-interlacer mode. Motion de-interlacer mode is only available for Interlaced inputs
Parameters: in - Input chnl (1-4) chnl 4 only for ImagePRO-SDI and ImagePRO-HD units
mode - De-interlacer mode [0-1] Motion | Fld->Frm
Query
DINT? in
Returns De-interlacer mode in the format
= mode
Example: DINT 1 1 (Set De-interlacer mode to Fld->Frm)
DINT? 1 (Queries De-interlacer mode for channel 1)
Command:
PCOMP in mode
Description: Sets the de-interlacer’s Pulldown Compensation mode.
Parameters: in - Input chnl [1-4] chnl 4 only for ImagePRO-SDI and ImagePRO-HD units
mode - [0 | 1] Disable | Enable
Query:
PCOMP? in
Returns the de-interlacer’s Pulldown Compensation mode in the format
= mode
Example: PCOMP 1 0 (Disables Pulldown Compensation mode for channel 1.)
PCOMP? 2 (Queries Pulldown Compensation mode of channel 2.)
Command:
FREEZ mode
Description: Enables/disables output Freeze
Parameters: mode - [0 | 1] Disable | Enable
Query:
FREEZ?
Returns the Freeze mode in the format
= mode
Example: FREEZ 1 (Freezes Image)
FREEZ? (Queries Freeze mode)
Command:
IAR in n cn
Description: Adjust Input Aspect Ratio.
Parameters: in - Input chnl (1-4) chnl 4 only for ImagePRO-SDI and ImagePRO-HD units