FOLSOM IP-2003 - Output Remote Commands

Manual # 26-0302000-00 / Revision E ImagePRO – Multi Format Image Processor
77
Output Remote Commands
Command:
GLMODE src type
Description: Sets Genlock Source and Genlock Type
Parameters: src [0-4], Freerun | Input Video | H+V Sync | C Sync | Black Burst
type [1-3], V Lock | HV Lock | HVScLock(Full lock)
Query:
GLMODE?
Returns the Genlock Source and Genlock Type in the format
= src type
Example: GLMODE 1 2 (Set Genlock Source to Input Video and Type to HV Lock)
GLMODE? (Queries Genlock Source and Genlock Type)
Command:
GLPHASE h sc
Description: Sets Genlock Horizontal Phase and SubCarrier Phase
Parameters: h – H Phase [ (-Input H Total/2) – (+Input H Total/2) ]
sc – SC Phase [-180 - +180]
Query:
GLPHASE?
Returns the Genlock Horizontal Phase and SubCarrier Phase in the format
= h sc
Example: GLPHASE 150 -100 (Set Genlock H Phase to 150 and SC Phase to -100)
GLPHASE? (Queries Genlock H Phase and SC Phase)
Command:
OBRT nnn.n
Description: Adjust Output Brightness. Only applicable if output is NTSC/PAL
Parameters: nnn.n - Output Brightness (100.0 – 114.0)
Query:
OBRT?
Returns the Output Brightness in the format
= nnn.n
Example: OBRT 100 (Adjusts Output Brightness to 100)
OBRT? (Queries Output Brightness)
Command:
OCNT nnn.n
Description: Adjust Output Contrast. Only applicable if output is NTSC/PAL
Parameters: nnn.n - Output Contrast (75.0 – 125.0)
Query:
OCNT?
Returns the Output Contrast in the format
= nnn.n
Example: OCNT 100 (Adjusts Output Contrast to 100)
OCNT? (Queries Output Contrast)
Command:
OCRST
Description: Reset Output Configuration.