78 ImagePRO – Multi Format Image Processor Manual # 26-0302000-00 / Revision E
Parameters: None
Example: OCRST (Reset Output Configuration)
Command:
OCSAV
Description: Save Output Configuration to non-volatile memory.
Parameters: None
Example: OCSAV (Save Output Configuration)
Command:
OCSP mode
Description: Sets Output Colorspace mode.
Parameters: mode - [0-1] RGB | YPbPr
Query:
OCSP?
Returns the Output Colorspace mode in the format
= mode
Example: OCSP 1 (Sets Output colorspace to YPbPr)
OCSP? (Queries Output Colorspace.)
Command:
OEQ mode
Description: Output Equalization mode. Only applicable if output is interlaced.
Parameters: mode – Disable/ Enable equalization mode (0 / 1)
Query:
OEQ?
Returns the Output Equalization mode in the format
= mode
Example: OEQ 0 (Enables Output Equalization mode)
OEQ? (Queries Output Equalization mode)
Command:
OFR mode
Description: Output Flicker Reduce mode. Only applicable if output is interlaced.
Parameters: mode – Disable/Enable flicker reduce mode (0 / 1)
Query:
OFR?
Returns the Output Flicker Reduce mode in the format
= mode
Example: OFR 0 (Enables Output Flicker Reduce mode)
OFR? (Queries Output Flicker Reduce mode)
Command:
OGM n
Description: Set Output Gamma.
Parameters: n - Output Gamma: n[1.0 – 3.0]
Query:
OGM?
Returns the Output Gamma value in the format
= n
Example: OGM 1.0 (Set Output Gamma to 1.0)
OGM? (Queries Output Gamma)
To Next Page
Loading...