Manual # 26-0302000-00 / Revision E ImagePRO – Multi Format Image Processor
79
Command:
OHATV nnnn
Description: Set Output Horizontal Active. The minimum and maximum limit is dependent on the output
resolution.
Parameters: nnnn - Output Horizontal Active: nnnn[ (Actual Output H Active * 2/10, with absolute minimum
value of 150) - +(Actual Output H Active * 6/5, with absolute maximum of Output H Total – Output H
Sync)]
Query:
OHATV?
Returns the Output Horizontal Active value in the format
= nnnn
Example: OHATV 1024 (Set Output Horizontal Active to 1024)
OHATV? (Queries Output Horizontal Active)
Command:
OHPOS nnnn
Description: Set Output Horizontal Position. The minimum and maximum limit is dependent on the output
resolution.
Parameters: nnnn - Output Horizontal Position: nnnn[(Output H Sync) - +(Output H Active )]
Query:
OHPOS?
Returns the Output Horizontal Position value in the format
= nnnn
Example: OHPOS 296 (Set Output Horizontal Position to 296)
OHPOS? (Queries Output Horizontal Position)
Command:
OHSYNC nnnn
Description: Set Output Horizontal Sync Width. The minimum limit is 4 and maximum limit is dependent on the
output resolution.
Parameters: nnnn - Output Horizontal Sync Width: nnnn[4 - (Output H Total -Output H Active – Output
Horizontal Front Porch –4)]
Query:
OHSYNC?
Returns the Output Horizontal Sync Width value in the format
= nnnn
Example: OHSYNC 120 (Set Output Horizontal Sync Width to 120)
OHSYNC? (Queries Output Horizontal Sync Width)
Command:
OHTOTAL nnnn
Description: Set Output Horizontal Total. The minimum and maximum limit is dependent on the output
resolution.
Parameters: nnnn - Output Horizontal Total: nnnn[(Output Hsync + Output Hactive + (Output Hpos – Output
Hsync)) - +(Actual Output H Total * 9/5)]
Query:
OHTOTAL?
Returns the Output Horizontal Total value in the format
= nnnn
Example: OHTOTAL 1344 (Set Output Horizontal Total to 1344)
OHTOTAL? (Queries Output Horizontal Total)
To Next Page
Loading...