3.1.1 Red Tag
There is a protective film on the screen, it is used to remove it. Please be
careful to remove.
3.1.2 SD Card Access Port
An SD card access port is located on the top right side of the monitor. The
SD card is the primary storage device on the monitor, onto which camera
video imagery is captured. You just need to press the memory card hard
and it will pop out or get stuck in. The monitor contains a 32GB SD Card.
(Supports 32-128GB SD card.)
3.1.3 Monitor and Harness Cables
The monitor has a 8-pin cable connector attached to it. This connector is
connected to a power cord harness which in turn connects to all of the
cameras and any activated trigger wire connections.
3.1.4 Monitor Buttons
（1）UP+: Function Increase Button
No effect on the main interface.
In the menu state, press it to select between these 6 menu options.
In the parameter, press it to increase, for example, if the “Brightness”
control is selected, press this button can increase the brightness of the
screen. To indicate this increase, a series of bars light up at the bottom of
the screen.
（2）MENU: Monitor System Menu Button
Press this button to enter menu settings.
When under menu/other options’ state, press it can exit and back to
previous panel.
To Next Page
Loading...