42
1. When pressing the M button to recall
the stored test results, blinking “
” will
be displayed on the main screen rst. If
you do not press the M button within 5
seconds, the blinking “
” will appear.
In the meantime, you can choose to insert
a test strip to start testing your blood or
to press the M button again to review the
stored test results.
2. When using the meter for the rst time, “---“
is displayed when you recall the test results
or review the average result. It means that
there is no test result in memory.
3. Anytime when you want to exit the memory,
keep pressing the M button for 3 second
until “OFF” displays. The meter then auto-
matically shut down.
4. If no button is pressed within 3 minutes,
the meter will show “OFF” and turn off
automatically.
NOTE
5. The control solution results are NOT stored in the memory (please also
go to page 26 WARNING for information). The list of past results and the
average result are for blood glucose results only.
To Next Page
Loading...
