15
If you do not want to set an alarm, press SET button to skip this step.
If you want to turn off an alarm, find the alarm number by pressing
SET button in the setting mode, press M button to change from
“
ON
’
to
“
OFF
”
.
At the time of your alarm, the
meter will beep and automatically
turn on. You can press M button
to silence the alarm and insert a
test strip to begin testing.
If you do not press M but
ton, the meter will beep for 2 minutes then
switch off.
If you do not want to test at this time, press M button to switch off
the meter.
NOTE
• These parameters can ONLY be changed in the setting mode.
• If the meter is idle for 3 minutes during the setting mode, it will switch off
automatically.
Congratulations! You have completed all settings!
To Next Page
Loading...
