EasyManuals Logo

Ford 2n series User Manual

Ford 2n series
106 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #90 background imageLoading...
Page #90 background image
FO-4 I&T (Remastered Ver.1.2 ) 05-24-2015
lever (62) by moving it to the UP position. Move the touch control lever down until
there is a gap “D” of ¾ inch between edge of lever and top of slot as shown. Raise
the lift arms to their top operating position as indicated by marks (R) being in
register. Make sure that the control arm (84) moves freely.
Move position control spring linkage up until pin (71) is in contact with face of
cam on lift ram arm. Raise the control arm (84) until swivel (80) comes into
contact with the flanged shoulder on bushing (79) of the constant draft control
spring. With parts held in this position, loosen the locking nut (68) and turn the
control rod (77) located inside spring (76) until the bolt contacts the pad (LP) on
the control arm (84). Recheck the position of touch control lever and lift arms to
be sure they were not moved during the adjustment, then tighten locknut (68)
securely.
LIFT COVER ASSEMBLY
Models 2N-9N
105. R&R COVER FROM
TRACTOR. To remove lift
cover unit from tractor,
first remove the tractor
seat and the inspection
plate from left side of axle
center housing as shown in
Fig. FO83. Working through
the inspection cover opening
spread the hand lift control
fork (53-Fig. FO84) until
lower ends of same are
released from the pump
control valve (11).
Disconnect the leveling rods
from the lift arms. Remove
the pin from the lift rocker
(106). Remove approximately
14 cap screws retaining
cover unit to center housing
and lift the assembly off
the housing. After
reinstalling cover adjust
the quadrant and control
spring as outlined in
paragraphs 99 and 100.
Connect/Report Errors jcchapster@gmail.com
Fig. FO82 - Adjusting the position (drawbar) control
spring (76) on 8N tractor.
R. Marks indicating top position of lift arms
62. Position (drawbar) control lever
68. Lock nut for position control spring
71. Pin
77. Lower end of position (drawbar) control rod
84. Lift control (lever) arm

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Ford 2n series and is the answer not in the manual?

Ford 2n series Specifications

General IconGeneral
BrandFord
Model2n series
CategoryLawn Mower
LanguageEnglish

Related product manuals