Seatbelts
SECOND ROW MIDDLE
SEATBELT
To fasten the seatbelt:
1. Pull the belt gently. It can be broken
if pulled sharply or if the vehicle is
on a slope.
2. Insert the smaller buckle into
the latch that has no belt release
button (position 2).
3 . Pull the larger buckle over your lap
and insert the buckle into the latch
that has the belt release button
(position 3).
In Order to Unfasten Your
Seatbelt Completely:
• Press the latch button that is
attached to the larger buckle to
partially release the belt, allowing it
to retract.
• Press the fastener button attached
to the smaller buckle (as shown in
the figure) in order to release the
belt. Allow the seatbelt to retract
completely and smoothly to the
roof position.
• Fit the 2 seat belt buckles into
the openings of the roof plastic
supports.
Smaller buckle being placed first,
followed by the larger one.
Note:
Using the seatbelt with the
unfastened detachable anchorage
hitch lug increases the chance of
serious or fatal injury in a collision.
Before using the seatbelt, make sure
that the detachable anchorage is
correctly locked.
It will also illuminate and sound if a front
seatbelt is unfastened when your vehicle
is moving.
If you do not fasten your seatbelt the
warning switches off automatically after
approximately five minutes.
Note:
If used constantly,
the seatbelt
can be fastened only into the smaller
buckle.
When not in use,
or when you
need to fold back the rear seat,
it is
necessary to release the seatbelt from
the smaller buckle.
Territory (CF4) Philippines, Vehicles Built From: 25-05-2020, EN, First Printing
t
To Next Page
Loading...
Need help?
General
