Run the door up and down to
make sure it clears the rail and
brackets. Then connect the ‘J’
bracket to the rail carriage.
Lift the opener to the horizontal. Measure the
height H from the top of the rail to some useful
fixing points, such as a roof joist. Bend up two
‘U’ brackets from the perforated strip supplied.
Open the garage door and align the motor head
laterally. Mark the ceiling. Lower the opener,
then fix the bracket to your ceiling marks. Fix
the third saddle clamp to the rail near to the
motor head, then bolt it to the hanging ‘U’
bracket, or a piece of angle.
Fix the second ‘U’ bracket half way along the
rail. This time you must use the two plastic rail
clamps because the J bracket passes this point
Check the rail is perfectly
level and secure. Brackets
may need slight bending.
The chain may scrape
inside the rail if it is not
true.
The opener is pre-wired with
a UK plug. On power up, the
courtesy light will come on
and the motor will beep. The
display will then show a
circulating pattern of LEDs.
To Next Page
Loading...