Format 11 Series - Rim Brake Adjustment; Shimano 3-Speed Planetary Hub Adjustment; Shimano 8-Speed Planetary Hub Adjustment

7776
Shimano 8-speed planetary hub
adjustment
— Set the Revo-shift lever to position 4.
— Turn the cable adjustment screw until the
yellow setting lines match. Turning the crank
forward, move the Revo-shift from 4 to 1,
and then from 1 back to 4. Repeat two to
three times to check the shift. Check again
the alignment of the yellow setting lines.
Shimano planetary hub adjustment
— Set the Revo-shift to 2.
— Then turn the cable adjustment screw until the red line on
the push rod matches the end of the hub axis. Turning the
crank forward, move the Revo-shift from 3 to 1 and then
from 1 back to 3 two to three times to check the shift. Then
move the Revo-shift shifter back to 2 and check if the red
line on the push rod matches the end of the hub axis.
— After adjusting the crankshaft, tighten the cable adjusting
screw nut to secure the screw.
Rim brake adjustment
— Establish brake shoes so that the brake surface of a shoe was parallel to the brake surface of
the rim and was located exactly in the middle.
— Tighten the adjustment screw on the brake lever all the way and unscrew it two turns.
Shimano 3-speed planetary hub adjustment
— Set the Revo-shift lever to position 2.
Stock
Hub axle end
Visible red
piston line
Adjusting bolt
Yellow line
Yellow mark on the lever
Lever movement
direction
Tighten
lock nut
Yellow alignment lines
CJ-8S2 0
JAPAN
L
O
C
K
CJ-8S2 0
JAPAN
L
O
C
K
C J
-
8
S 2
0
J
A
P
A
N
L
O
C
K
When the bike is stationary
The yellow alignment lines on the star lock are in
two places.
Use the one that is easier to see.
When the bike is upside down
Should be straight
Drum
castle stars
Drum
castle stars
Holder
castle stars
Holder
castle stars
Should be straight
Install on «4»
Cable adjustment screw