5958
Attention! The removal of the threaded steering column has a special mark, above which it
should not rise. It may be called Minimum insertion, Min. insertion, Maximum extension, Max.
extension, Min or Max.
Remember that the seller (manufacturer) is not responsible for malfunctions, injuries or damage
resulting from improper assembly of the bike, which was carried out independently or by
persons who are not professional cycle mechanics.
Adjustment of control mechanisms
In most cases, handlebar controls are represented by switches and brake handles. You can
adjust the angle of their installation and the distance from the center of the handle¬bar. Ask
the seller to make these adjustments, if necessary. After changing the position of the control
mechanisms, tighten all connections with the recommended force.
General Transmission Operating Rules
— A multi-speed transmission is a technically sophisticated bicycle hub that requires professional
tuning by a qualied technician. A properly tuned transmission will last you longer and will work
more efciently without requiring additional interventions and adjustments.
— When cycling, select the most suitable star ratio for your area. Do not allow a strong skew of
the chain that occurs when it is installed on the largest or smallest gears in the back and front at
the same time. This can lead to premature wear of the chain and gears.
— Remember that gears must be shifted while driving: for proper gear shifting, you must
simultaneously pedal and the rear wheel of a bicycle. When shifting gears, loosen the pedal
effort and make a full pedal turn. The chain will snap onto the desired star. Shifting without
relieving force can damage the bike’s transmission. Do not attempt to shift gears without scrolling
the chain. This may knock down the setting of the switches.
— Do not apply excessive force when pressing the shifter levers.
— Monitor the status of driven gears. You must be sure that they do not have bent or broken
teeth.
Break-in period
The bicycle has a so-called break-in period, after which it is necessary to re-adjust and adjust
the main components of the bicycle. After the rst few trips (about 50 km), contact the store
where you purchased the bike, or an authorized service center to set up and adjust the bike.
Some stores provide free after-sales service. You can nd out the conditions and detailed
information in the store where the bike was purchased. If the break-in is carried out according
to the Guide, the bike will last longer.
Attention! It is recommended to regularly check the technical condition of the bike by
inspecting it by qualied specialists in a store or an authorized service center.
4. GENERAL TRANSMISSION OPERATING RULES
Right Not right
To Next Page
Loading...