Format 11 Series - Cameras; Handlebar Adjustment; Steering Angle Adjustment; Tires

6968
Tires
— On the sidewalls of tires, the dimension, the recommended pressure and, in some cases,
the recommended operating conditions are indicated. The behavior of tires, and therefore the
handling of a bicycle, is largely dependent on pressure. Check tire pressure regularly.
— Tires may have a directional tread pattern. It is necessary that the arrow indicated on the
sidewall coincides with the rotation of the wheel.
— To inate a Schrader-type chamber with a nipple, unscrew the cap, screw the pump tip onto
the nipple shaft and inate the wheel to the recommended pressure, then unscrew the pump tip
and put the nipple cap back on. If you need to lower the camera, just press on the rod located
inside the nipple.
— Presta type nipples are found exclusively on bicycle cameras. To inate a chamber with a
Presta type nipple, remove the cap, unscrew the lock screw of the safety screw and press to
release it, then screw the pump tip onto the nipple shaft and inate the wheel to the recommended
pressure. If you need to lower the camera, unscrew the safety screw, press and hold it pressed.
— Watch for tire wear. The tread and sidewalls must not be damaged. A worn tread increases
the likelihood of a puncture tubes and loss of traction on the wheel.
Cameras
Bicycle chambers can have one of two main types of nipples: automobile (Schrader) or bicycle
(Presta). Be careful when choosing a bicycle pump: the pump tip must be of the appropriate
type.
Steering angle adjustment
The handlebar should be adjusted so that the landing
is comfortable and convenient, and the grip with
both hands ensures condent control of the bike.
— Loosen the screws that secure the extension cover.
— Turn the handlebar to the desired angle.
— Tighten the screws of the stem cover.
Tighten evenly to the recommended torque
value.
Handlebar adjustment
The adjustment of the position of the handlebar
relative to the steering rod of the fork must be
made so that the handlebar is installed in a plane
strictly perpendicular to the plane of the front
wheel.
— Loosen the offset screws.
— Set the stem to the desired position.
— Tighten the screws.
Nipple Schrader Nipple Presta