Format kappa 40 - 8.8 Setting the parallel cutting fence

Panel Saws
kappa 30/kappa 40
Panel Saw
Kappa 30 / kappa 40
Making adjustments and preparations
8.8 Setting the parallel cutting fence
8.8.1 Setting the parallel cutting fence
Fig. 46: Setting the parallel cutting fence
Sliding:
1. 
2. 
3. 

4. 

5. 
6. 


  
  
  
!   #
"   $
Option: Digital position display:



!
Attention: To operate, programm and calibrate etc. the digital position display, read the separate operation
manual „Position display“.
Fig. 47: Digital position display

!
"
#
$
$

!