Format kappa 40 - 8.19.2 Chucking the grooving tools

Panel Saw
Kappa 30 / kappa 40
Making adjustments and preparations
8.19.2 Chucking the grooving tools
Fig. 81: Remove the saw blade

 
 
 
1. 
2. 
3. 


4. 
5. 
6. 
!  $
" %
§  &
7. 
8. 
9. 
10.
11.
/   BL
(   BM
‘  BN
Fig. 82: Flange/Loading board
Attention: A spacer ring has to be fitted onto the saw shaft prior to using grooving tooling with a width
less than 10 mm!

!
"
#
$
%
&
/
)
*
BN
BM
BL