Format kappa 40 - Adjusting the Width Automatic; Changing the Scoring Blade Automatic

Panel Saw
Kappa 30 / kappa 40
Making adjustments and preparations
8.18 Changing the scoring blade „Automatic“
Fig. 75: Dismantling the scoring blade
8.17.1 Adjusting the width „Automatic“

 
 



1. 

2. 





3. 

!  #
"  $
Fig. 74: Scoring blade Adjusting the width
Attention! Only twist the adjusting screw if the clamping screw is loose!
Only adjust the width of the scoring blade so the saw-teeth of both scoring blades still overlap. Rec-
ommendation: Maximum cutting width of 3.6 mm.
Attention: If working without a scoring unit, install the protector tube to prevent resinous residue building up.

 
 
1. 
2. 
3. 


4. 
5. 
!
"

!
#
"
$

!
"