Format kappa 40 - 8.11 Adjusting;changing the speed

Panel Saw
Kappa 30 / kappa 40
Making adjustments and preparations
4. 
5. 
Reducing speed:
 
 
Increasing speed:
 
 
6. 
7. 
8. 
" $
# %
Fig. 62: Speed Set
8.11.3 Speed control with a frequency changer
Fig. 63: Control panel/Potentiometer
Attention! Risk of material damage! Never exceed the maximum speed indicated on the tool!
8.11.2 Changing the speed
1. 
2. 

3. 
!
Fig. 61: Changing the speed


!
Note: Variable speed control (Option) Opera-
tion, programming, calibration etc., see sepa-
rate „x-motion control“ instructions manual,
section positioning control.

$
"
#
%
!
!
