SUPPORT AND MAINTENANCE
of the printer. Three main maintenance processes you might have to check once in a
1. Cleaning the Print Plate
of glue before each print. But in order for the adhesion to be successful, you
will have to clean the Print Plate with water and remove the old glue that you
previously applied. Make sure that after every print you clean the Print Plate
with water, remove the water with a dry cloth and apply a layer of glue only on
a cleaned Print Plate before starting a print.
2. Cleaning the Print-Head
Head is jammed.
Please visit formon3d.com/support for detailed instructions on how to clean
the Print-Head.
3. Cleaning the Filament Extruder
the drive gear is cleaned.
Please visit formon3d.com/support for detailed instructions on how
to clean the extruder.
Visit formon3d.com/support for more detailed instruction on Maintenance
processes.
SOFTWARE AND FIRMWARE UPDATES
HELP AND SUPPORT | 32
To Next Page
Loading...