TROUBLESHOOTING
FILAMENT IS NOT EXTRUDING FROM THE PRINT-HEAD -
- Please go to formon3d.com/support
2. Clean the Print-Head - Please go to formon3d.com/support
Please go to formon3d.com/support
PRINT NOT STICKING TO THE BUILD PLATE -
applied earlier, clean the build plate with water and apply the Glue Stick again. Keep in
mind that you have to clean the Print Plate before every print, and apply a new layer of
glue on it before starting the print.
CANNOT EXTRUDE/EXTRACT THE FILAMENT WHEN INSERTING IT - Two issues can
the Print-Head this might be an indication that the Print-Head is jammed.
A jammed print head means there are clogs created on the bottom of the
Please follow the detailed instructions on formon3d.com/support on how to
Clean the Print-Head and DO NOT proceed with cleaning without checking and
following the instructions online.
by itself even after you have given it a push, it might be an indication that
Please follow the detailed instructions on formon3d.com/support on how to
Clean the Print-Head and DO NOT proceed with cleaning without checking and
following the instructions online.
HELP AND SUPPORT | 33
To Next Page
Loading...