TROUBLESHOOTING
CANNOT RETRACT THE FILAMENT WHEN REMOVING IT - Two issues can cause this
A jammed print head means there are clogs created on the bottom of the
Please follow the detailed instructions on formon3d.com/support on how to
Clean the Print-Head and DO NOT proceed with cleaning without checking and
following the instructions online.
Please follow the detailed instructions on formon3d.com/support on how to
Clean the Print-Head and DO NOT proceed with cleaning without checking and
following the instructions online.
PRINTED OBJECT IS STUCK TO THE BUILD PLATE -
object from the build plate, take a thin metal craft spatula and carefully work the blade
under the object while twisting the hand slightly. Be careful if you remove a stuck
object using a knife or a sharp object because you can injure yourself and damage the
build plate.
HELP AND SUPPORT | 34
To Next Page
Loading...