FORST TR6 - Control Panel and Settings; Ignition Switch Operation

P a g e | 12
Machine operation
STANDARD PROGRAMME
MACHINE USE
TOUCH SENSOR HOPPER
STAGE
1
Fold down hopper tray
Start engine.
Turn ignition key to pre-heat
2
Wait for display to indicate"Start
Engine"
Turn key to start engine and let go once
engine has fired
3
Allow engine to run for 30 seconds then
open throttle to full
4
For forward feed, touch green button
twice
5
Feed material
6
To stop, touch red button or push trip bar
7
To reverse feed, touch green button
once
8
To stop machine
9
Touch red button or push trip bar
10
Close throttle to minimum
11
Switch off ignition and remove key
12
Before transporting machine
14
Sweep out debris from hopper
15
Close hopper tray by lifting fully up
against stops and engage latch
ORANGE BUTTON
PROGRAMME MACHINE USE
TOUCH SENSOR HOPPER
STAGE
1
Fold down hopper tray
Start engine.
Turn ignition key to pre-heat
2
Wait for display to indicate"Start
Engine"
Turn key to start engine and let go once
engine has fired
3
Allow engine to run for 30 seconds then
open throttle to full
4
For forward feed, touch green button
once
5
Feed material
6
To stop, push e-stop button or push trip
bar
7
To reverse feed, touch orange button
once for short reverse or twice for
continual
8
To stop machine
9
Touch e-stop button or push trip bar
10
Close throttle to minimum
11
Switch off ignition and remove key
12
Before transporting machine
14
Sweep out debris from hopper
15
Close hopper tray by lifting fully up
against stops and engage latch