P a g e | 30
Engine bay
8
ANVIL CLAMP BOLT
Blade Changing
WARNING – Rigger Gloves must be worn whilst changing the blades
WARNING – It is essential that only genuine parts are used guaranteeing the correct
grade of Blade, bolt, washer and nut
1. Turn off chipper and remove the ignition keys
2. Disconnect battery leads
3. Remove the two bolts holding the chipping chamber lid closed (pic 1)
4. Carefully open the chipping chamber lid from the chute side and let it come to
rest on the hinge stops
To Next Page
Loading...
