38 01-28005-0026-20041101 Fortinet Inc.
Next steps NAT/Route mode installation
To register the FortiGate unit
After purchasing and installing a new FortiGate unit, you can register the unit by going
to the System Update Support page, or using a web browser to connect to
http://support.fortinet.com and selecting Product Registration.
To register, enter your contact information and the serial numbers of the FortiGate
units that you or your organization have purchased. You can register multiple
FortiGate units in a single session without re-entering your contact information.
To configure virus and attack definition updates
Go to the FortiGate web-based manager Update Center to configure the FortiGate
unit to automatically receive new versions of the virus definitions and attack definitions
are available.
1 Go to System > Maintenance > Update Center.
2 Select Refresh to test the FortiGate unit connectivity with the FortiProtect Distribution
Network (FDN).
To be able to connect to the FDN the FortiGate unit default route must point to a
network such as the Internet to which a connection to the FDN can be established.
If FortiProtect Distribution Network changes to Available, then the FortiGate unit can
connect to the FDN.
3 Select Scheduled Update and configure a schedule for receiving antivirus and attack
definition updates.
4 Select Apply.
5 You can also select Update Now to receive the latest virus and attack definition
updates.
For more information about FortiGate settings please see the FortiGate Online Help or
the FortiGate Administration Guide.
To Next Page
Loading...
Need help?
General