Safety information
—————————————————————————————————————–———
———————————————————————————–––––––––––––––––––––––––
Operating Manual Skiving Machine ES 50-UK-V3/24.01.2012 20 von 45
1.7.7 Inspection requirements
The machine operator is bound to regularly inspect the basic units of the
machine that are important for the operational safety and to replace them in
case of a fault or wear.
The machine is subject to the inspection obligation for electric systems.
The machine must be checked regularly according to the regulations of the
industrial sector and the local regulations.
Obvious damages and the function of the tensioning equipment of the knife,
all drive elements and the guide elements which are in contact with the
knife must always be inspected when the knife is replaced.
The function of the safety switches must be inspected when maintenance
work is carried out.
1.7.8 Further safety rules
During the working process there remains a small risk of injury because
complete protection in the working zone of the knife during the skiving
process of leather parts is not possible.
This zone is marked with a danger label (pictograph). The machine has
been designed for optimum safety in accordance with the latest technical
safety standards.
For further information about safety rules, please refer to this Operating
Manual as well as to the national and international safety recommendations
and laws.
To Next Page
Loading...