Installing the machine
—————————————————————————————————————–———
———————————————————————————–––––––––––––––––––––––––
Operating Manual Skiving Machine ES 50-UK-V3/24.01.2012 25 von 45
Installation of the machine
1.10
1.10.1 Transport
The machine is transported on a pallet.
For the installation of the machine at its place of destination the metallic
straps with which the machine is fixed on the pallet must be removed.
When lifting the machine please consider
the appropriate angle of the rope (at least 45°) and
the load-carrying capacity of the rope.
1.10.2 Unpacking the machine
Carefully unpack the machine and inspect the packing material before its
disposal.
The tools and the accessory parts which are required for the machine have
been wrapped and placed in the scrap material bin which is located on the
lower left side on the front of the machine. Therefore, open the scrap
material bin door and pull the recessed grip to draw out the scrap material
bin.
Inspect the machine for damage and missing parts. Please refer to Chapter
1.1.5 Tools and accessories (page 10).
To Next Page
Loading...