CAUTION: If your camera works well with the current firmware, we recommend not upgrading. Please
don’t upgrade the firmware unnecessarily. Your camera may be damaged if misconfigured during an
upgrade.
NOTE:
Before upgrade the firmware, please unplug the SD card and reboot the camera, don’t upgrade the
firmware in WAN through the web UI, or else the upgrade process may be failed.
Please ensure you have download the correct firmware package for your camera before upgrading.
Read the upgrade documentation (readme.txt file) in the upgrade package before you upgrade.
Upon downloading the firmware check the sizes of the bin files. They must match the size in the
readme.txt file. If not, please download the firmware again until the sizes are the same. Your camera will
not function correctly if a corrupt .bin file is used.
Normally, only Device WEB UI need to be upgrade, please do not try to upgrade the Device System
Firmware.
1) Never shut down the power of the camera during upgrade until the IP camera restart and get
connected.
2) After upgrade successfully, please uninstall the old plugin and re-install it, then reset the camera to the
default factory settings before using the camera.
4.10.3 Patch Installation
Click "Browse" to select the correct patch file, and then click "Install Patch" to install the patch. Do not
turn off the power during it installing. After installing is complete, you will receive a system prompt.
To Next Page
Loading...
