Foscam FI9853EP - Patch Installation; Factory Reset

www.foscam.com
Shenzhen Foscam Intelligent Technology Co., Limited
Tel: 86 755 2674 5668 Fax: 86 755 2674 5168
63
4) Normally, only Device WEB UI need to be upgrade, please do not try to upgrade the Device Firmware.
5) Never shut down the power of the camera during upgrade until the IP camera restart and get connected.
6) After upgrade successfully, please clear the cache of browser, uninstall the old plugin and re-install it, then
reset the camera to the default factory settings before using the camera.
4.8.3 Patch Installation
Click "Browse" to select the correct patch file, and then click "Install Patch" to install the patch. Do not turn off
the power during it installing. After installing is complete, you will receive a system prompt.
Figure 4.70
4.8.4 Factory Reset
Click Factory Reset button and all parameters will return to factory settings if selected.
Figure 4.71
4.8.5 Reboot
Click Reboot to reboot the camera. This is similar to unplugging the power to the camera.
Figure 4.72