Foster FD2-10 User Manual

7
FPS Controller Default Parameter Values
Parameter
Range
Description
Default FD2-10
SCL
Readout Scale:
2°C
1°C
Range -50/-9.9…. 19.9/80°C (With INP = SN4 Only)
2°C
Range -50 …. 120°C
°F
Range -55 …. 240°F
SPL
-50 … SPH
Minimum Limit for SP setting
1
SPH
SPL …120°
Maximum limit for SP setting
3
SP
SPL … SPH
Temperature set point to be achieved
2
C-H
Temperature Control mode:
REF
REF
Refrigeration
HEA
Heating
HYS
1 … 10°
Off/On Thermostat differential
3
CRT
0 … 30min
Compressor Rest Time
2
CT1
0 … 30min
Thermostat run time with faulty T1 probe.
(CT1 = 0 output with faulty T1 will always be off)
6
CT2
0 … 30min
Thermostat off time with faulty T1 probe.
(CT2=0 & CT1 = >0 output with faulty T1 will always be on)
4
CSD
0 … 30min
Compressor stop delay after door has been opened
(Only if DS = YES)
1
DFM
Defrost Start Mode:
TIM
Non
Defrost function is disabled
TIM
Regular time defrost
FRO
Defrost time elapses only in condition of frost accumulation
DFT
0…99 Hours
Time interval between defrosts
6
DFB
Defrost timer clock
YES
YES
Following mains interruption, timer resumes count
NO
Following mains interruption, timer restarts from zero
DLI
-50.. 120°
Defrost end temperature
(Only if T2 = EPO)
N/A
DTO
1 … 120min
Maximum defrost duration
20
DTY
Defrost Type:
OFF
OFF
Timed off cycle defrost (compressor and heater off)
ELE
Electric heater defrost (compressor off, heater on)
GAS
Hot gas defrost (compressor and heater on)
DPD
0 … 240 sec
Evaporator pump down. Timed pause at start of defrost
0
DRN
0 … 30min
Drain down period
2
DDM
Defrost display mode:
DEF
RT
Real (actual) air temperature
LT
Last temperature display before start of defrost
SP
The current set point value.
DEF
“DEF”

Foster FD2-10 Specifications

General

Brand	Foster
Model	FD2-10
Category	Controller
Language	English