Fostex HP-A8MK2 - Page 16

16
Listening
Setting item Setting value
"USB MUTE SEL"
Activates cross-fade processing
(volume down) between les
when the input source is set to
"USB".
Default: "OFF"
"OFF"
Play the signal from USB directly. A snapping noise may
be produced between les.
"ON"
Activates cross-fade processing at the beginning and end
of the le. For the continuously recorded sound source,
such as a live recording album, sound may be interrupted
for a moment.
"SD REPEAT MODE"
Selects the repeat range of the
SD card playback.
Default: "FOLDER"
"FOLDER"
Repeats the current folder ("F" indicator is displayed).
"ALL"
Repeats the whole card ("A" indicator is displayed).
"SINGLE"
Repeats the current le ("1" indicator is displayed).
"LCD ON/OFF"
Selects the lighting pattern of
the LCD display.
Default: "ON"
"ON"
LCD is always on.
"OFF"
The LCD turns o automatically approximately 8 seconds
after the last operation is performed.
"AUTO POWER OFF"
Selects the ''AUTO POWER OFF''
mode ON or OFF.
Default: ''ON''
"ON":
The HP-A8
MK2 will automatically turn OFF the power,
when the operation continues for about 30 minutes.
"OFF'':
The HP-A8
MK2 does not automatically power OFF. i.e., it
keeps powering ON even after 30 minutes of operation.
"SYSTEM INFO"
Displays the current software
version.
Default: "VerX.XXX"
"VerX.XXX"
Current version.
"VERSION UP"
Executes the update. (page 18)
"RESET"
Returns to the factory settings (page 17).