605-01-323 9
10. Check that the suspension has proper clearance by steering completely in both directions.
11. Set vehicle back on the ground and drive it back and forth several feet to allow the suspension to settle.
Now measure ride height and make adjustments if necessary. * PLEASE READ INSTALLATION GUIDELINES
ON HOW TO PROPERLY ADJUST PRELOAD
12. It is highly recommended that you have your wheel alignment checked.
CHECK AND FINAL DETAILS
8. Reconnect the upper ball joint at the knuckle, torque to OE specifications. Make sure to reinstall any
brackets or wires that were previously removed.
9. Reinstall the outer tie rod ends and torque to OE specifications.
To Next Page
Loading...
