605-01-323 7
RESERVOIR BRACKET INSTALLATION
4. Install the supplied Group A remote reservoir mounting brackets to the frame of the vehicle (Fig. 1).
Fig. 1: Left side of the vehicle is shown.
Fig. 2: The OE radiator bracket is used to mount the
reservior bracket.
4B. Drill a 13/64” pilot hole in the frame using the
obtained location.
4C. Secure the reservoir bracket to the frame using
one of the Group B self-tapping screws. Torque the
radiator bracket bolt to OE specifications.
4D. Repeat steps 4A-4C to the other side of the
vehicle.
4A. Utilize the OE radiator bracket’s bolted joint to
locate the reservoir bracket’s front mounting hole
(Fig 2). Adjust the bracket to fit flush to the frame.
Mark the frame for drilling the remaining bolting
location. In the absence of the OE radiator bracket
hardware use the supplied bolt and clip nut.
NOTICE: The purchase of appropriate clip-on nuts
and bolts may be required for vehicle variants
where the pictured radiator bracket is not used.
To Next Page
Loading...
