Fox FLOAT X2 User Manual

3
Your shock has a 4 digit ID code on the shock body. Use this number on
the Help page at www.ridefox.com to find out more information about your
shock, including shock travel.
Suggested Sag Measurements
Travel 30% sag (Plush)
51 mm/ 2.00in 15 mm/ 0.60in
55 mm/ 2.25in 17 mm/ 0.68in
65 mm/ 2.50in 19 mm/ 0.75in
70 mm/ 2.75in 21 mm/ 0.82in
75 mm/ 3.00in 22 mm/ 0.90in
89 mm/ 3.50in 27 mm/ 1.05in
The recommended settings in this tuning guide are designed
to be a starting point, in order to get you out on your first ride
in as few steps as possible. Consult your bike manufacturer’s
instructions for setup recommendations.
As you ride and get used to your new shock, adjust your settings as needed.
Detailed information and videos can be found in the online owner’s manual.

Fox FLOAT X2 Specifications

General

Type	Rear Shock
Shaft Material	Aluminum
Body Material	Aluminum
Spring Type	Air
Adjustments	Low-speed compression, high-speed compression, low-speed rebound, high-speed rebound
Air Spring	EVOL
Sizes	Available in various eye-to-eye lengths and stroke sizes
Intended Use	Enduro, Downhill
Travel	Varies (depends on bike model)
Compatibility	Designed for frames that accommodate metric or imperial sized rear shocks. Compatible with frames designed for Trunnion or standard eyelet mounting.