35
3
Integrated Peripherals
► OnChip IDE Devices / OnBoard Devices / SuperIO Devices / USB Devices Setting
Press <Enter> to go to relative submenu.
OnChip IDE Devices
► IDE HDD Block Mode
If your IDE hard drive supports block mode, select [Enabled] for automatic detection of the
optimal number of block read/write per sector.
► IDE DMA Transfer Access
[Disabled] : to disable DMA transfers for all IDE drives. They will revert to PIO mode transfers.
[Enabled] : to enable DMA transfers for all IDE drives. The proper DMA mode will be detected
at boot-up. If the drive does not support DMA transfers, then it will use PIO mode instead.
Recommend leaving this BIOS feature at the default [Enabled] setting. You should only disable
Phoenix - AwardBIOS CMOS Setup Utility
Integrated Peripherals
► OnChip IDE Devices [Press Enter] Item Help
► OnBoard Devices
[Press Enter]
► SuperIO Devices
[Press Enter] Menu Level ►
► USB Devices Setting
[Press Enter]
↑↓→←:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5: Previous Values F7: Optimized Defaults
Press Enter
Phoenix - AwardBIOS CMOS Setup Utility
OnChip IDE Devices
IDE HDD Block Mode [Enabled] Item Help
IDE DMA Transfer Access [Enabled]
On-Chip Primary PCI IDE
[Enabled] Menu Level ►
IDE Primary Master PIO [Auto] If your IDE hard drive
IDE Primary Slave PIO [Auto]
supports block mode
IDE Primary Master UDMA [Auto] select Enabled for
IDE Primary Slave UDMA [Auto]
automatic detection of
On-Chip Secondary PCI IDE
[Enabled] the optimal number of
IDE Secondary Master PIO [Auto] block read/writes per
IDE Secondary Slave PIO [Auto]
sector the drive can
IDE Secondary Master UDMA [Auto] support.
IDE Secondary Slave UDMA
[Auto]
*** On-Chip Serial ATA Setting ***
SATA Controller [Enhanced Mode]
SATA Port Speed Settings
[Force GEN II]
x PATA IDE Mode Primary
SATA Port P1,P3 is Secondary
↑↓→←:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5: Previous Values F7: Optimized Defaults
Enabled
To Next Page
Loading...
