31
3
Advanced BIOS Features
► Removable Device Priority
This option is used to select the priority for removable device.
► Hard Disk Boot Priority
This option is used to select the priority for HDD startup. After pressing <Enter>, you can
select the HDD using the Up/Down arrow keys, and change the HDD priority using <PageUp>/
<PageDown>; you can exit this menu by pressing <Esc>.
► CPU L1 & L2 Cache
Enable/Disable CPU cache setting. L1, L2 cache are small, fast memory caches that are built
into a CPU and help speed access to important and frequently-used data. L1 cache is typically
smaller and faster than L2 cache. L1 cache is an abbreviation of Level 1 cache.
► Hyper-Threading Technology
This option is used to enable or disable the Hyper-Threading technology. Enable this feature
will always turn on APIC Mode.
This option will be displayed only if your CPU is supporting this feature.
► First/Second/Third Boot Device
These three options allow you to select the priority of boot sequence from different devices.
► Boot Other Device
With this function set to enable, the system will boot from some other devices provided that the
rst/second/third boot devices failed. The options are: Disabled and Enabled.
► Boot Up NumLock Status
This item denes if the keyboard Num Lock key is active when your system is started. The
available settings are: On (default) and Off.
► Security Option
When it is set to “Setup”, a password is required to enter the CMOS Setup screen; When it
is set to “System”, a password is required not only to enter CMOS Setup, but also to start up
your PC.
► APIC Mode (Advanced Programmable Interrupt Controller)
This item is used to enable or disable APIC function.
Phoenix - AwardBIOS CMOS Setup Utility
Advanced BIOS Features
► Removable Device Priority [Press Enter] Item Help
► Hard Disk Boot Priority
[Press Enter]
CPU L1 & L2 Cache [Enabled]
Menu Level ►
Hyper-Threading Technology
[Enabled] Select Removable Boot
First Boot Device [Hard Disk]
Device Priorty
Second Boot Device
[CDROM]
Third Boot Device
[Removable]
Boot Other Device
[Enabled]
Boot Up NumLock Status
[On]
Security Option
[Setup]
x APIC Mode
Enabled
Delay For HDD (Seconds)
[ 2]
Full Screen Logo Show
[Enabled]
↑↓→←:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5: Previous Values F7: Optimized Defaults
Press Enter
To Next Page
Loading...
Need help?
General
