3
34
DRAM Timing Conguration
► Memory Speed Mode
This item is used tu enable/disable provision of DRAM timing by SPD device.The Serial Pres
ence Detect (SPD) devise is a small EEPROM chip,mounted on a DDR3 memory module.It
contains inportant information about the module’s speed,size,addressing mode and various
other parameters,so that the motherboard memory controller (chipset) can better access the
memory device.
Select [AUTO] for SPD enable mode.
Select [Limit], the DRAM speed will not exceed the specied value listed in the “Memory“
Select [Manual],then DRAM speed is manually selected according to the set value of “Memory
Speed Adjust“.
► DRAM Timing Mode
When both DCTs (DRAM controller) are enabled in unganged mode, BIOS must initialize
the frequency of each DCT in order, you also can congure the timings manually.
Settings are : [Auto], [DCT 0], [DCT 1], [Both].
CMOS Setup Utility - Copyright (C) 1985-2008, American Megatrends, Inc.
DRAM Timing Configuration
DRAM Timing Configuration
Help Item
Memory Speed Mode
DRAM Timing Mode [Auto]
Auto
Limit
Manual
↑↓←→:Move Enter:Select +/-/:Value F10:Save ESC:Exit
F1:General Help F9:Optimized Defaults
[Auto]
Options
To Next Page
Loading...
Need help?
General
