Foxconn G45M Series - SuperIO Configuration

3
38
SuperIO Conguration
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
SuperIO Conguration
SuperIO Conguration
Help Item
OnBoard Floppy Controller
[Enabled] Allows BIOS to Enable
Serial Port1 [Enabled]
or disable oppy
IrDA Function [Enabled] controller.
IrDA Duplex Mode
[Half Duplex]
OnBoard CIR Port [Disabled]
↑↓←→:Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help
F9:Optimized Defaults
[Enabled]
► OnBoard Floppy Controller
This item is used to enable/disable Floppy Controller.
► Serial Port1
This item is used to enable/disable Serial Port 1.
► IrDA Function
This item is used to enable/disable onboard infrared chip function.
► IrDA Duplex Mode
This item enables you to determine the transfer mode of the onboard infrared chip.
► OnBoard CIR Port
This item species the base I/O port address of the onboard Consumer IR (CIR) port. The
setting values are: [Disabled] (default) ; [3E0] ; [2E0] ; [298] . Set this value to [Disabled] can
prevent the Onboard CIR Port from accessing any system resources. When the value of this
option is set to [Disabled], the consumer infrared port becomes unavailable.
► OnBoard CIR IRQ
When the value of “OnBoard CIR Port” is set to [3E0], [2E0] or [298], this item is used to set
the onboard CIR IRQ.