Foxconn MARS - Install a New Windows XP

93
5
5-4 Install a New Windows XP
1. Press <DEL> to enter BIOS Setup during POST.
2. Insert the Windows installation CD into the optical drive.
3. Set the “First Boot Device” to “CDROM”, save changes and exit the BIOS setup.
4. The computer will reboot, and it will start installing Windows Operating System.
Watch the screen carefully, when the following picture appears, press <F6> key
immediately. If you forgot to do this, PC will go to an fatal blue screen, and you
may need to reboot the system again. PC may not respond to your <F6> input
immediately, and it keeps loading les until the next screen displays.
Phoenix - AwardBIOS CMOS Setup Utility
Advanced BIOS Features
► Hard Disk Boot Priority Press Enter ▲ Item Help
Virus Warning
Enabled █
First Boot Device
CDROM █ Menu Level ►
Second Boot Device
Hard Disk █
Third Boot Device
USB-ZIP █ Select Hard Disk Boot
Boot Other Device
Enabled █ Device Priority
Boot Up Floppy Seek
Disabled █
Boot Up NumLock Status
on █
Gate A20 Option
Fast █
Typematic Rate Setting
Disabled █
x Typematic Rate (Chars/Sec) 6 █
x Typematic Delay (Msec) 250
█
Security Option
Setup █
APIC Mode
Enabled █
MPS Version Control for OS
1.4 █
OS Select For DRAM > 64MB
Non-OS2 █
Report No FDD For WIN 95
No ▒
Full Screen LOGO Show
Enabled ▒
Small LOGO(EPA) Show
Disabled ▼
↑↓←→:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F6:Fail-Safe Defaults F7:Optimized Defaults
CDROM
Windows Setup
Press F6 if you need to install a 3rd party SCSI or RAID driver.
When you set the SATA Mode in BIOS to either AHCI or RAID, you need
to follow these steps to install your Windows XP system.
C
A
U
T
I
O
N
!