Foxconn MARS - Pnp;Pci Configurations

36
3
PnP/PCI Congurations
► Init Display First
This item is used to choose the initial display device which will be used rst when your PC
starts up. Options are : [PCI Slot] and [PCIEx].
► Resources Controlled By
This item is used to dene the system resource control scheme. If all cards you use support
PnP, then select [Auto] and the BIOS will automatically distribute interruption resources. If
the PCI cards you installed need special IRQ resources, you will need to select [Manual] and
manually adjust interruption resources in the event of hardware conicts.
► IRQ Resources
Press the <Enter> key, then manually set IRQ resources.
► PCI/VGA Palette Snoop
This option is only useful if you use an MPEG card or an add-on card that makes use of the
graphics card's Feature Connector. It corrects incorrect color reproduction by "snooping"
into the graphics card's frame buffer memory and modifying (synchronizing) the information
delivered from the graphics card's Feature Connector to the MPEG or add-on card. It will also
solve the problem of display inversion to a black screen after using the MPEG card. Feature
Connector normally stays at top edge of the graphics card.
► INT Pin 1/2/3/4/5/6/7/8 Assignment
This item is used to assign IRQ resources for INT Pin 1/2/3/4/5/6/7/8. Default INT Pin
assignments can be found from the help menu.
***PCI Express relative items***
► Maximum Payload Size
This item is used to set maximum Transaction Layer Packets (TLP) payload size for PCI
Express devices. The unit is byte.
Phoenix - AwardBIOS CMOS Setup Utility
PnP/PCI Congurations
Init Display First PCI Slot Item Help
Resources Controlled By
Auto Menu Level ►
x IRQ Resources Press Enter
PCI/VGA Palette Snoop
Disabled
INT Pin 1 Assignment
Auto
INT Pin 2 Assignment
Auto
INT Pin 3 Assignment
Auto
INT Pin 4 Assignment
Auto
INT Pin 5 Assignment
Auto
INT Pin 6 Assignment
Auto
INT Pin 7 Assignment
Auto
INT Pin 8 Assignment
Auto
** PCI Express relative items **
Maximum Payload Size
128
↑↓→←:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F6:Fail-Safe Defaults F7:Optimized Defaults
PCI Slot