20
2
2-6 Onboard Button
Power on Button: POWER_ON
Push the power on button to power on the system.
Reset Button: RESET
Push the reset button to reboot the system.
Clear CMOS Button: CLS_CMOS
Turn off the AC power supply, push the CLS_CMOS button
and hold there for a couple of seconds to clear CMOS.
2-7 Onboard LED
+5V Standby LED:
It will light whenever the power supply that connected to
the motherboard is switched on.
DRAM Power LED:
The LED lights up indicating the system is on or the system
is staying at S1 or S3 sleeping state.
POWER_ON RESET CLS_CMOS
■ Make sure the power supply is turned off before pressing the CLS_CMOS button to
clear CMOS.
■ Push down the CLS_CMOS button and hold it there for a couple of seconds to clear
the CMOS completely, then release.
C
A
U
T
I
O
N
!
Do not remove or plug in any device when the onboard LED is lighting on.
W
A
R
N
I
N
G
!
To Next Page
Loading...
