Foxconn MARS - Gladiator BIOS

38
3
This item shows the Current NBFan Speed auto-detected by the system.
► Current CPU/DRAM/NB Voltage
These items show the Current CPU/DRAM/NB Voltage detected automatically by the system.
► Current + 5.0V / + 12V / + 3.3V / VBAT
These items show the + 5.0V / + 12V / + 3.3V / VBAT Voltage detected automatically by the
system.
Gladiator BIOS
► CPU Feature/Memory Timing Cong/All Voltage Control/OC Gear
Press <Enter> to go to each Submenu.
► Over Clock (O.C.) Phase Select
It allows you to select the over clock phase. Setting values: [O.C. Disabled]; [Manual O.C.];
[Instant O.C.].
► Instant OverClocking
This item is used for instant OverClocking, you may choose over clock instantly by 5%,
10%,15%.....etc.
***Ratio and Clock Setting***
► CPU Clock Ratio Unlock
This item is used to enable or disable the CPU Clock Ratio Unlock.
► CPU Clock Ratio
This item is used to set the ratio of an unlocked CPU. Using different CPU, the setting values
are different.
► CPU Clock
This item allows you to adjust the CPU clock.
► CPU Clock vs Memory Speed
This item allows you to set the ratio between CPU Clock and Memory Speed.
► System Memory Frequency
This item shows the System Memory Speed.
► PCI Express Clock
This item allows you to adjust the PCI Express bus clock.
Phoenix - AwardBIOS CMOS Setup Utility
Gladiator BIOS
► CPU Feature Press Enter Item Help
► Memory Timing Config
Press Enter
► All Voltage Control
Press Enter Menu Level ►
► OC Gear
Press Enter
Over Clock Phase Select
O.C. Disabled
Instant OverClocking Default
******* Ratio and Clock Setting *******
CPU Clock Ratio Unlock Disabled
x CPU Clock Ratio 9 X
Target CPU Core Speed
1800MHz
CPU Clock 200MHz
CPU Clock vs Memory Speed Auto
System Memory Speed
800MHz
PCI Express Clock 100MHz
PCI Clock 33.6MHz
************ Miscellaneous ************
Auto Detect PCI Clock
Enabled
Spread Spectrum
Enabled
Over Clock Recovery
Disabled
↑↓→←:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F6:Fail-Safe Defaults F7:Optimized Defaults
Press Enter