In case of installation in PV system, startup of the unit (i.e. start of designated
operation) is prohibited until it is determined that the full system meets the
requirements stipulated in EC Directive (2014/35/EU,2014/30/EU, etc.)
The grid connected inverter leave the factory completely connecting device
and ready for connection to the mains and PV supply, the unit shall be
installed in accordance with national wiring regulations. Compliance with
safety regulations depends upon installing and configuring system correctly,
including using the specified wires. The system must be installed only by profes-
sional installers who are familiar with requirements for safety and EMC. The
installer is responsible for ensuring that the end system complies with all the
relevant laws in the country where it is to be used.
The individual subassembly of the system shall be interconnected by means of
the wiring methods outlined in national/international such as the national
electric code (NFPA) No.70 or VDE regulation 0107.
To Next Page
Loading...
