No direct sunlight No rain exposure No snow buildup Direct sunlight Rain exposure Snow lay up
5.3
Installation Precaution
E/F Series inverters are designed for outdoor installation (IP65). Make sure the
installation location meets the following conditions:
·
Not in direct sunlight.
·
Not in areas where highly flammable materials are stored. Not in potential
explosive areas.
·
Not in the cool air directly.
·
Not near the television antenna or antenna cable.
·
Not higher than altitude of 3000m above sea level.
·
Not in environment of high precipitation or humidity (＞95%).
·
Be sure the ventilation is adequate.
·
The ambient temperature in the range of -20℃ to +60℃.
·
The slope of the wall should be within ±5°.
·
The wall where the inverter is mounted should meet conditions below:
1.
Solid brick/concrete, or strength equivalent mounting surface;
2.
Inverter must be supported or strengthened if the wall’s strength isn’t
sufficient (such as wooden wall or where the wall is covered by thick layer of
decoration)
Please avoid direct sunlight, rain exposure, or the build-up of snow during
installing
and
operat
ion
.
Available Space Size
To Next Page
Loading...
