Please confirm whether the tablet has enough battery.
2：Q: Receiver powers up normally but there is no signal output.
Please make sure the ID, channel, and airspeed of the receiver are set to be
the same as the ones of the remote controller.
3：Q: The receiver SBUS has a signal output, but the serial port is not able to
connect, or the transmission signal is garbled.
Please make sure the serial port baud rate of the remote controller and the
receiver are the same and set the corresponding baud rate of the ground
software.
4：Q：There is interference when two or more devices are working at the same
time.
Please note that the ID of each set must be different and the channels must
be set to different signals to avoid any interference.
To Previous Page
Loading...