Fractal AXE-FX III - Page 84

78
12 SETUP MENU
PARAMETER Description
Scene Revert
ON/OFF
Selects between two different ways for scenes to work when you change them
via a Footswitch or MIDI:
“OFF” (Default): Scene edits are RETAINED across Scene changes as long as
you do not change PRESETS. So if you tweak Scene 1, switch to Scene 2, then
switch back to Scene 1, your tweaks will still be intact.
“ON”: Scene edits are LOST if you change the Scene without saving. So if you
tweak Scene 1, switch to Scene 2, then back to Scene 1, Scene 1 will have
reverted to its previously saved state. This makes Scene changes feel more like
traditional preset changes.
Effect Bypass Mode
VALUE/TOGGLE
This setting determines how MIDI messages set the Bypass State of a block.
When set to “Value” the bypass state is controlled by the CC value (0–63=OFF,
64–127=ON). When set to “Toggle” the bypass state toggles whenever the CC
message is received, regardless of the value (0–127).
Send Realtime Sysex
ON/OFF
This determines whether real-time MIDI SysEx messages for tuner and tempo
will appear at the MIDI OUT port.
Program Change
ON/OFF
Determines whether the Axe-Fx III will process or ignore incoming MIDI Program
Change messages.
Ignore Redundant PC
ON/OFF
This setting determines whether the Axe-Fx III should re-process or ignore
a Program Change message that corresponding to the current preset. With
this setting “OFF”, a preset will be reloaded—all changes discarded—when it
is selected again via PC. This allows you, for instance, to load a preset, use
various “Instant Access” switches to bypass effects, and then stomp the
footswitch that originally selected the preset to have it revert to its saved state.
With this setting “ON”, redundant PC messages are ignored. When PC mapping
is used, if the current Scene has changed, the preset will not reload but the
Scene will still revert to that set in the map.
Send MIDI PC
1–16
OMNI
OFF
Determines whether or not the Axe-Fx III will automatically transmit a MIDI
Program Change message at its MIDI OUT port when a new preset is loaded.
This is the easiest way for most people to operate a single connected MIDI
device while changing presets on the Axe-Fx III. Any custom MIDI mapping
is left to the downstream device. To use this feature you simply select which
channel you want the message to be transmitted on. The “OMNI” setting
transmits the message on all channels.