Fractal AXE-FX III - Page 86

80
12 SETUP MENU
jack, or via the USB connection of the Axe-Fx III. Each of these settings is global. In every case, the method for
mapping a controller to one of these functions is the same:
1. Use the NAV knob to select the desired function.
2. Use the VALUE knob to assign a controller to the function:
 1—127 to assign a MIDI CC#.
 PEDAL 1 or PEDAL 2 to assign a pedal connected to the on-board expression jacks of the Axe-Fx III.
 FC__ PEDAL 1–4 to assign a pedal connected to the corresponding pedal jack of the designated FC controller.
 FC__ SW 1–4 to assign a switch connected to the corresponding switch jack of the designated FC controller.
 NONE to remove all assignments from the selected item.
MIDI/REMOTE: CHANNEL PAGE
The Channel page works exactly like the Bypass page except the entries are used to set the Channel of each
block instead of its bypass state. The value of the CC message sets the channel as follows:
0 = Channel A 1 = Channel B 2 = Channel C 3 = Channel D
The series continues, repeating A, B, C, D for values up to 127 (D).
For additional information, see "Channel Select" on p. 46.
MIDI/REMOTE: EXTERNAL PAGE
Controller assignments for the sixteen External Controllers used in Modiers (See Section 9: Modiers).
MIDI/REMOTE: LOOPER PAGE
Controller assignments for the functions of the Looper.