23
5 FOOTSWITCH FUNCTIONS
5 FOOTSWITCH FUNCTIONS
Footswitch functions are arranged in CATEGORIES, detailed here.
To assign functions, use the EZ page (see p.17) or the Edit Layout/Switch pages (see p.19).
Select a Category and a Function, then set the values of any parameters for that function.
LED RING COLORS
Each footswitch Category has its own default color which appears automatically when you assign
the switch. You can change the category colors using a list found in the Cong menu:
CHANGE A CATEGORY COLOR:
On the Axe-Fx III, open Setup | FC Controllers and page to the “ tab.
NAV to the desired category and turn the VALUE knob to specify the desired color from the list.
You can also set the color for an individual switch:
CHANGE A SWITCH COLOR:
Find the switch using the EZ page (see p.17) or the Edit Layout/Switch pages (see p.19).
Set “Switch Ring Color” to the desired value.
The LED Ring color for per-preset switches is ALWAYS determined by the settings in the preset.
You cannot change Per-Preset colors through the FC Controllers menu (see p.34).
To set either the Tap or the Hold function of any switch to do nothing, change the Category to “Unassigned”.
To Next Page
Loading...
